Lambretta Layshaft Fitting Sleeve Tool MRB (L0-161-7671800)

It is important, when checking the tolerances in the gearbox, 

that the layshaft is pulled all the way into the rear hub bearing, as far as it will go.

One way is to fit the rear hub and tighten it up but this can be difficult on the workbench.

As an alternative Mark Broadhurst came up with this sleeve, 

once the layshaft has been fitted with a soft hammer fit this sleeve over the layshaft then fit and tighten the rear hub nut.

This has the same effect of pulling the layshaft into position allowing you to check the tolerances correctly.

• Lambretta
  
  • LI 125 (series 1)
  • LI 150 (series 1)
  • LI 125 (series 2)
  • LI 150 (series 2)
  • TV 175 (series 2)
  • DL/GP 125
  • DL/GP 150
  • DL/GP 200
  • LI 125 (series 3)
  • LI 150 (series 3)
  • LI 125 Special
  • LI 150 Special
  • X 150 Special
  • X 200 Special
  • TV 175 (series 3)
  • TV 200
  • GP 125 (SIL)
  • GP 150 (SIL)
  • GP 200 (SIL)
  • Eibar LI 125 (series 2)
  • Eibar LI 150 (series 2)
  • Eibar TV 175 (series 2)
  • Serveta 200 Jet
  • Serveta 125 Lince
  • Serveta 150 Lince
  • Serveta 200 Lince
  • Serveta 125 Special
  • Serveta 150 Special
  • Serveta 125 Scooterlinea
  • Serveta 150 Scooterlinea
  • Serveta 175 Scooterlinea
  • Serveta 200 Scooterlinea